2012 Infiniti M35hFACTORY OEM SERVICE PROCEDURE

Component Function Check

  1. PERFORM COMPONENT FUNCTION CHECK-I

    ⓧ Without CONSULT 

    1. Perform "INSPECTION MODE 5". Refer to "DESCRIPTION ".
    2. Start engine and warm it up to the normal operating temperature.
    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Drive the vehicle at speed of 100 km/h (62 MPH) for at least 1 minutes.
      CAUTION: Always drive vehicle at a safe speed.
    5. Stop the vehicle and set selector lever to P position.
    6. Check the voltage between ECM harness connector terminals under the following condition.
      DTC ECM Condition Voltage
      Connector Terminal
      + -
      P0139 F102 76 84 Revving up to 3, 000 RPM under no load at least 10 times A change of voltage should be more than0.08 V for 1 second during this procedure.
      P0159 80

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: GO TO 2.

  2. PERFORM COMPONENT FUNCTION CHECK-II

    Check the voltage between ECM harness connector terminals under the following condition.

    DTC ECM Condition Voltage
    Connector Terminal
    + -
    P0139 F102 76 84 Keeping engine at idle for 10 minutes A change of voltage should be more than0.08 V for 1 second during this procedure.
    P0159 80

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: GO TO 3.

  3. PERFORM COMPONENT FUNCTION CHECK-III

    Check the voltage between ECM harness connector terminals under the following condition.

    DTC ECM Condition Voltage
    Connector + -
    Terminal Terminal
    P0139 F102 76 84 Coasting from 100 km/h (62 MPH) on the suitable gear position A change of voltage should be more than0.08 V for 1 second during this procedure.
    P0159 80

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Proceed to "DIAGNOSIS PROCEDURE ".

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.