2012 Infiniti G25 BaseFACTORY OEM SERVICE PROCEDURE

ASCD Brake Switch

WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.

The ASCD brake switch is installed to the brake pedal bracket. The switch detects state of the brake pedal and transmits an ON/OFF signal to VCM.

The contact of the ASCD brake switch is usually closed. When the brake pedal is depressed, it opens to disconnect the circuit, and shut off the output voltage. This constitutes an ASCD brake switch signal.

Fig 1: Identifying ASCD Brake Switch
G07084021Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.