Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Infiniti G25 BaseFACTORY OEM SERVICE PROCEDURE
Component Function Check
WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FUNCTION
- Select "PUSH SW" in "Data Monitor" mode with CONSULT.
- Check power switch (push switch) signal under the following conditions.POWER SWITCH (PUSH SWITCH) SIGNAL CHECK CONDITIONS
Test item Condition Status PUSH SW Power switch (push switch) is pressed ON Power switch (push switch) is not pressed OFF Is the indication normal?
YES: INSPECTION END.
NO: Go to "DIAGNOSIS PROCEDURE ".
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.