Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Infiniti G25 BaseFACTORY OEM SERVICE PROCEDURE
Data Monitor
WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.
ALL SIGNALS
- Displays the status of the following vehicle signals inputted into the AV control unit.
- For each signal, actual signal can be compared with the condition recognized on the system.DATA MONITOR DISPLAY ITEM REFERENCE CHART
Display Item Display Vehicle status Remarks VHCL SPD SIG On Vehicle speed > 0 km/h (0 MPH) Changes in indication may be delayed. This is normal. Off Vehicle speed = 0 km/h (0 MPH) PKB SIG On Parking brake is applied. Off Parking brake is released. ILLUM SIG On Block the light beam from the auto light optical sensor when the light switch is ON. - Off Either of the following conditions - Lighting switch OFF
- Expose the auto light optical sensor to light when the light switch is ON.
IGN SIG On Ignition switch ON Off Ignition switch in ACC position REV SIG On Selector lever in R position Changes in indication may be delayed. This is normal. Off Selector lever in any position other than R
WORK SUPPORT
Neutral position adjustment of the steering angle sensor can be performed.
CAUTION:
Perform adjustment at the support side of the ABS actuator control unit for vehicle with VDC. For detail, Refer to
"WORK PROCEDURE
"
WORK SUPPORT ITEM DESCRIPTION CHART
| Item name | DESCRIPTION |
|---|---|
| ST ANGLE SENSOR ADJUSTMENT | Perform neutral position adjustment of the steering angle sensor. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
