Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Infiniti G25 BaseFACTORY OEM SERVICE PROCEDURE
Stroke Sensor 0 Point Learning: Description
WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Always perform stroke sensor 0 point learning before driving after any of the following operations is performed.
STROKE SENSOR 0 POINT LEARNING PROCEDURE REFERENCE
| x: Necessary, -: Not necessary | |
|---|---|
| Procedure | Stroke sensor 0 point learning |
| Electrically-driven intelligent brake unit is removed. | x |
| Electrically-driven intelligent brake unit is replaced. | x |
| Stroke sensor is removed. | x |
| Stroke sensor is replaced. | x |
| Brake pedal is removed. | x |
| Brake pedal is replaced. | x |
| Brake pedal heights are adjusted. | x |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.