2012 Infiniti FX50FACTORY OEM SERVICE PROCEDURE

DTC Inspection Priority Chart

If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart:

Priority DTC
1 B2562: LOW VOLTAGE
2
  • U1000: CAN COMM
  • U1010: CONTROL UNIT(CAN)
3
  • B2190: NATS ANTENNA AMP
  • B2191: DIFFERENCE OF KEY
  • B2192: ID DISCORD BCM-ECM
  • B2193: CHAIN OF BCM-ECM
  • B2195: ANTI SCANNING
4
  • B2553: IGNITION RELAY
  • B2555: STOP LAMP
  • B2556: PUSH-BTN IGN SW
  • B2557: VEHICLE SPEED
  • B2560: STARTER CONT RELAY
  • B2601: SHIFT POSITION
  • B2602: SHIFT POSITION
  • B2603: SHIFT POSI STATUS
  • B2604: PNP/CLUTCH SW
  • B2605: PNP/CLUTCH SW
  • B2608: STARTER RELAY
  • B260A: IGNITION RELAY
  • B260F: ENG STATE SIG LOST
  • B2614: BCM
  • B2615: BCM
  • B2616: BCM
  • B2617: BCM
  • B2618: BCM
  • B261A: PUSH-BTN IGN SW
  • B261E: VEHICLE TYPE
  • B26EA: KEY REGISTRATION
  • U0415: VEHICLE SPEED SIG
5
  • B2621: INSIDE ANTENNA
  • B2623: INSIDE ANTENNA
6 B26E7: TPMS CAN COMM
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.