2012 Infiniti FX35 AWDFACTORY OEM SERVICE PROCEDURE

CONSULT-III Function: Function

CONSULT-III can display each diagnostic item using the diagnostic test modes shown in the following chart:

DIAGNOSTIC TEST MODE FUNCTION CHART

Diagnostic test mode Function
ECU identification E-SUS control unit part number can be read.
Self-diagnosis result Self-diagnostic results can be read and erased quickly. (1)
Data monitor Input/Output data in the E-SUS control unit can be read.
Active test CONSULT-III drives some actuators via E-SUS, and changes some command signal values within the specified range.
(1) If the memory in E-SUS control unit is erased, the DTC diagnosis result is also erased.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.