2012 Infiniti FX35 AWDFACTORY OEM SERVICE PROCEDURE

Component Description

DAMPING CONTROL SYSTEM COMPONENTS REFERENCE CHART

Component Reference/function
E-SUS control unit "DESCRIPTION "
Front body vertical G sensor "DESCRIPTION "
Front wheel vertical G sensor "DESCRIPTION "
Rear body vertical G sensor "DESCRIPTION "
Shock absorber actuator "DESCRIPTION "
Mode select switch (E-SUS mode select) "DESCRIPTION "
Sport mode indicator lamp "DESCRIPTION "
Steering angle sensor Transmits the steering angle signal to E-SUS control unit via CAN communication.
ABS actuator and electric unit (control unit) Transmits mainly the following signals to E-SUS control unit via CAN communication.
  • Vehicle speed signal
  • Brake pressure control signal
  • Brake lamp switch signal
ECM Transmits mainly the following signals to E-SUS control unit via CAN communication.
  • Requested torque signal
Unified meter and A/C amp. Transmits mainly the following signals from E-SUS control unit via CAN communication.
  • Sport mode indicator lamp signal
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.