Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Infiniti EX35 Base, RWDFACTORY OEM SERVICE PROCEDURE
General Specifications
| Cylinder arrangement | V-6 | |
| Displacement cm3 (cu in) | 3, 498 (213.45) | |
| Bore and stroke mm (in) | 95.5 x 81.4 (3.760 x 3.205) | |
| Valve arrangement | DOHC | |
| Firing order | 1-2-3-4-5-6 | |
| Number of piston rings | Compression | 2 |
| Oil | 1 | |
| Number of main bearings | 4 | |
| Compression ratio | 10.6 | |
| Compression pressure kPa (kg/cm2 , psi)/300 RPM | Standard | 1, 275 (13.0, 185) |
| Minimum | 981 (10.0, 142) | |
| Differential limit between cylinders | 98 (1.0, 14) | |
| Cylinder number | ||
| Valve timing (Valve timing control - "OFF") |
||
| Unit: degree | |||||
|---|---|---|---|---|---|
| a | b | c | d | e | f |
| 248 | 248 | 2 | 66 | 0 | 68 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
