2012 Infiniti EX35 Base, AWDFACTORY OEM SERVICE PROCEDURE

Input/Output Signal Chart

Sensor Input signal to ECM ECM function Actuator
Crankshaft position sensor (POS) Engine speed(1) Cooling fan control IPDM E/R
↓
Cooling fan control module
↓
Cooling fan motor
Camshaft position sensor (PHASE)
Engine coolant temperature sensor Engine coolant temperature
Refrigerant pressure sensor Refrigerant pressure
Battery Battery voltage(1)
Unified meter and A/C amp. Vehicle speed(2)
Air conditioner ON signal(2)
A/C evaporator temperature(2)
Target A/C evaporator temperature(2)
(1) The ECM determines the start signal status by the signals of engine speed and battery voltage.
(2) This signal is sent to ECM through CAN communication line.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.