2012 Infiniti EX35 Base, AWDFACTORY OEM SERVICE PROCEDURE

Component Inspection

  1. CHECK FUEL FILLER CAP
    1. Turn ignition switch OFF.
    2. Remove fuel filler cap.
    3. Wipe clean valve housing.
      Fig 1: Identifying Spring, Pressure Valve, Vacuum Valve, Plate And Gasket
      G04874784Courtesy of NISSAN NORTH AMERICA, INC.
    4. Install fuel filler cap adapter (commercial service tool) to fuel filler cap.
    5. Check valve opening pressure and vacuum.

      Pressure: 15.3 - 20.0 kPa (0.156 - 0.204 kg/cm 2  , 2.22 - 2.90 psi) 

      Vacuum: -6.0 to -3.3 kPa (-0.061 to -0.034 kg/cm 2  , -0.87 to -0.48 psi) 

      Fig 2: Checking Valve Opening Pressure And Vacuum
      G04874785Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: GO TO 2.

  2. REPLACE FUEL FILLER CAP

    Replace fuel filler cap.

    CAUTION: Use only a genuine fuel filler cap as a replacement. If an incorrect fuel filler cap is used, the MIL may come on.

    : INSPECTION END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.