Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Function Check
- CHECK HIGH PRESSURE FUEL PUMP FUNCTION
WITH CONSULT-III
- Start engine.
- Check "FUEL PRES SEN V" in "DATA MONITOR" mode with CONSULT-III.MONITOR ITEM CONDITION
Monitor Item Condition Values/Status FUEL PRES SEN V Engine speed: Idle 980 - 1, 200 mV Engine speed: Revving engine from idle to 4, 000 RPM quickly 1, 100 - 2, 900 mV
WITHOUT CONSULT-III
- Start engine.
- Check the voltage between ECM harness connector and ground.VOLTAGE SPECIFICATION
ECM Condition Voltage + - Connector Terminal Connector Terminal F110 105 E80 175 [Engine is running] - Warm-up condition
- Idle speedNOTE: The pulse cycle changes depending on RPM at idle
BATTERY VOLTAGE (11 - 14 V)* [Engine is running] - Warm-up condition
- Engine speed: 2, 000 RPM
BATTERY VOLTAGE (11 - 14 V)* Is the inspection result normal?
YES: INSPECTION END
NO: Proceed to "DIAGNOSIS PROCEDURE ".
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.