2011 Infiniti M37 SportFACTORY OEM SERVICE PROCEDURE

Diagnosis Procedure

  1. CHECK GROUND CONNECTION
    1. Turn A/C switch and blower fan switch OFF.
    2. Turn ignition switch OFF.
    3. Check ground connection M95. Refer to Ground Inspection in "CIRCUIT INSPECTION ".

      Is the inspection result normal? 

      YES: GO TO 2.

      NO: Repair or replace ground connection.

  2. CHECK REFRIGERANT PRESSURE SENSOR POWER SUPPLY CIRCUIT
    1. Disconnect refrigerant pressure sensor harness connector.
    2. Turn ignition switch ON.
    3. Check the voltage between refrigerant pressure sensor harness connector and ground.
      VOLTAGE REFERENCE

      Refrigerant pressure sensor Ground Voltage (V)
      Connector Terminal
      E77 3 Ground Approx. 5

      Is the inspection result normal? 

      YES: GO TO  4.

      NO: GO TO 3.

  3. DETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors M6, E106
    • Harness for open or short between ECM and refrigerant pressure sensor

      Repair open circuit, short to ground or short to power in harness or connectors.

  4. CHECK REFRIGERANT PRESSURE SENSOR GROUND CIRCUIT FOR OPEN AND SHORT
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check the continuity between refrigerant pressure sensor harness connector and ECM harness connector.
      CONTINUITY REFERENCE

      Refrigerant pressure sensor ECM Continuity
      Connector Terminal Connector Terminal
      E77 1 M107 112 Existed
    4. Also check harness for short to ground and short to power.

      Is the inspection result normal? 

      YES: GO TO  6.

      NO: GO TO 5.

  5. DETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors M6, E106
    • Harness for open or short between ECM and refrigerant pressure sensor

      Repair open circuit, short to ground or short to power in harness or connectors.

  6. CHECK REFRIGERANT PRESSURE SENSOR INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
    1. Check the continuity between refrigerant pressure sensor harness connector and ECM harness connector.
      CONTINUITY REFERENCE

      Refrigerant pressure sensor ECM Continuity
      Connector Terminal Connector Terminal
      E77 2 M107 105 Existed
    2. Also check harness for short to ground and short to power.

      Is the inspection result normal? 

      YES: GO TO  8.

      NO: GO TO 7.

  7. DETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors M6, E106
    • Harness for open or short between ECM and refrigerant pressure sensor

      Repair open circuit, short to ground or short to power in harness or connectors.

  8. CHECK INTERMITTENT INCIDENT

    Refer to "INTERMITTENT INCIDENT ".

    Is the inspection result normal? 

    YES: Replace refrigerant pressure sensor.

    NO: Repair or replace.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.