Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Infiniti M37 SportFACTORY OEM SERVICE PROCEDURE
Component Function Check
- CHECK ASCD INDICATOR FUNCTION
Check ASCD indicator under the following conditions.
CONDITION REFERENCEASCD INDICATOR CONDITION SPECIFICATION CRUISE LAMP - Ignition switch: ON
- MAIN switch: Pressed at the 1st time → at the 2nd time
ON → OFF SET LAMP - MAIN switch: ON
- When vehicle speed is between 40 km/h (25 MPH) and 144 km/h (89 MPH)
- ASCD: Operating
ON - ASCD: Not operating
OFF Is the inspection result normal?
YES: INSPECTION END
NO: Go to "DIAGNOSIS PROCEDURE ".
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.