2011 Infiniti M37 BaseFACTORY OEM SERVICE PROCEDURE

Brake Actuator: Notes

WARNING: This page is about a different car, the 2012 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The test can be performed only when the engine is running.
Test item Operation Description "PRESS SENS" value
BRAKE ACTUATOR MODE1 Transmits the brake fluid pressure control signal to the ABS actuator and electric unit (control unit) via CAN communication 10 bar
MODE2 20 bar
MODE3 30 bar
Test start Starts the tests of "MODE1", "MODE2" and "MODE3" -
Reset Stops transmitting the brake fluid pressure control signal below to end the test -
End Returns to the "SELECT TEST ITEM" screen -
NOTE: The test is finished in 10 seconds after starting
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.