Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Work Procedure
- WRITE VEHICLE SPECIFICATION
CONSULT Configuration
Write vehicle specification into AV control unit.
To write vehicle specification stored in CONSULT into the AV control unit: GO TO 2.
To write vehicle specification into the AV control unit by hand: GO TO 3.
- WRITE STORED DATA
CONSULT Configuration
Select "After Replace ECU" in "Read/Write Configuration." Write data stored in CONSULT with the "Before Replace ECU" function into the AV control unit.
: GO TO 4.
- MANUALLY WRITE VEHICLE SPECIFICATION
CONSULT Configuration
Perform "Manual Configuration." Refer to the CONFIGURATION LIST to write vehicle specification into the AV control unit. Refer to "CONFIGURATION LIST ".
: GO TO 4.
- OPERATION CHECK
Check that the operation of the AV control unit and camera images (fixed guide lines and predictive course lines) are normal.
: WORK END
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.