Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Infiniti M37 BaseFACTORY OEM SERVICE PROCEDURE
Component Inspection
- CHECK ACCELERATOR PEDAL POSITION SENSOR
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Turn ignition switch ON.
- Check the voltage ECM harness connector terminals as per the following.VOLTAGE REFERENCE
ECM Condition Voltage (V) Connector + - Terminal Terminal M107 97 (APP sensor 1) 100 Accelerator pedal Fully released 0.45 - 1.0 Fully depressed 4.2 - 4.8 98 (APP sensor 2) 104 Fully released 0.22 - 0.50 Fully depressed 2.1 - 2.5 Is the inspection result normal?
YES: INSPECTION END
NO: GO TO 2.
- REPLACE ACCELERATOR PEDAL ASSEMBLY
- Replace accelerator pedal assembly.
- Go to
"SPECIAL REPAIR REQUIREMENT ".
INSPECTION END
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.