Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Infiniti FX50FACTORY OEM SERVICE PROCEDURE
Component Description
WARNING: This page is about a different car, the 2011 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT DESCRIPTION
| Component | Reference |
|---|---|
| IPDM E/R | POWER CONTROL SYSTEM |
| Ignition relay (Built-in IPDM E/R) | B260A IGNITION RELAY |
| Ignition relay (Built-in fuse block) | B2553 IGNITION RELAY |
| Accessory relay | B2614 ACC RELAY |
| Blower relay | B2615 BLOWER RELAY CIRCUIT |
| Stop lamp switch | B2555 STOP LAMP |
| Transmission range switch | B2604 PNP SWITCH |
| Push-button ignition switch | PUSH-BUTTON IGNITION SWITCH |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.