2011 Infiniti FX50FACTORY OEM SERVICE PROCEDURE

BCM Control Function List

WARNING: This page is about a different car, the 2011 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
BCM CONTROL FUNCTION LIST

System Reference
Combination switch reading system "SYSTEM DIAGRAMΒ "
Signal buffer system "SYSTEM DIAGRAMΒ "
Power consumption control system "SYSTEM DIAGRAMΒ "
Auto light system
Turn signal and hazard warning lamp system
Headlamp system
Parking, license plate and tail lamps system
Front fog lamp system
Exterior lamp battery saver system
Daytime running light system
Interior room lamp control system "SYSTEM DIAGRAM "
Step lamp system
Interior room lamp battery saver system "SYSTEM DIAGRAM "
Front wiper and washer system "SYSTEM DIAGRAM "
Rear wiper and washer system "SYSTEM DIAGRAM "
Warning chime system "WARNING CHIME SYSTEM : SYSTEM DIAGRAM "
Door lock system "SYSTEM DIAGRAM "
Infiniti Vehicle Immobilizer System (IVIS) - NATS "SYSTEM DIAGRAM "
Vehicle security system "SYSTEM DIAGRAM "
Panic alarm
Automatic drive positioner system "AUTOMATIC DRIVE POSITIONER SYSTEM : SYSTEM DIAGRAM "
Rear window defogger system "SYSTEM DIAGRAM "
Intelligent Key system/engine start system Door lock unlock function "INTELLIGENT KEY SYSTEM : SYSTEM DIAGRAM "
Remote keyless function
Back door open function
Warning function
Key reminder function
Engine start function
Power window system "SYSTEM DIAGRAM "
Retained accessory power (RAP) system "SYSTEM DESCRIPTION "
Tire pressure monitor system (TPMS) - AIR PRESSURE MONITOR "TIRE PRESSURE MONITORING SYSTEM : SYSTEM DESCRIPTION "
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.