WARNING: This page is about a different car, the 2011 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

Vehicle specification needs to be written with CONSULT because it is not written after replacing BCM. Configuration has three functions as follows.

CONFIGURATION FUNCTIONS CHART

Function	Description
READ CONFIGURATION	Reads the vehicle configuration of current BCM. Saves the read vehicle configuration.
WRITE CONFIGURATION - Manual selection	Writes the vehicle configuration with manual selection.
WRITE CONFIGURATION - Config file	Writes the vehicle configuration with saved data.
NOTE: Manual setting item: Items which need selection by vehicle specifications Automatic setting item: Items which are written in automatically (Setting can not be changed) For some models and specifications, the automatic setting item may not be displayed.

CAUTION: When replacing BCM, always perform "WRITE CONFIGURATION" with CONSULT. Or not doing so, BCM control function does not operate normally.

Complete the procedure of "WRITE CONFIGURATION" in order.
Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
Never perform "WRITE CONFIGURATION" except for new BCM.
If you set incorrect "WRITE CONFIGURATION", incidents might occur.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Configuration (BCM): Description

Use the Manual With the Right Hardware

When to See a Mechanic