Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Infiniti M45 BaseFACTORY OEM SERVICE PROCEDURE
DTC Confirmation Procedure
NOTE:
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next step.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, do not add fuel .
- Start engine and warm it up to normal operating temperature.
- Rev engine up to 2, 000 RPM for more than 10 minutes.
- Move the vehicle to a cool place, then stop engine.
- Check resistance between "fuel level sensor and fuel pump" terminals 4 and 5.
- Soak the vehicle until the resistance between "fuel level sensor and fuel pump" terminals 4 and 5 becomes 0.5 kΩ higher than the value measured before soaking.CAUTION: Never turn ignition switch ON during soaking.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
