2010 Infiniti M45 BaseFACTORY OEM SERVICE PROCEDURE

Throttle Position Sensor

  1. Reconnect all harness connectors disconnected.
  2. Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
  3. Turn ignition switch ON.
  4. Set selector lever to the D position.
  5. Check voltage between ECM terminal 50 (TP sensor 1 signal) and ground, ECM terminal 69 (TP sensor 2 signal) and ground under the following conditions.
    VOLTAGE CONNECTOR TERMINALS REFERENCE CHART

    Terminal Accelerator pedal Voltage
    50
    (Throttle position sensor 1)
    Fully released More than 0.36 V
    Fully depressed Less than 4.75 V
    69
    (Throttle position sensor 2)
    Fully released Less than 4.75 V
    Fully depressed More than 0.36 V
    Fig 1: Checking Throttle Position Sensor Voltage
    G04900228Courtesy of NISSAN MOTOR CO., U.S.A.
  6. If NG, replace electric throttle control actuator and go to the next step.
  7. Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
  8. Perform "IDLE AIR VOLUME LEARNING ".
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.