2010 Infiniti M45 BaseFACTORY OEM SERVICE PROCEDURE

Battery Current Sensor

  1. Reconnect harness connectors disconnected.
  2. Disconnect battery negative cable (1).
    • Vehicle Front
    Fig 1: Disconnecting Battery Negative Cable
    G06303356Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Install jumper cable A between battery negative terminal and body ground.
  4. Turn ignition switch ON.
  5. Check voltage between ECM terminal 71 (battery current sensor signal) and ground.

    Voltage: Approximately 2.5 VΒ 

  6. If NG, replace battery negative cable assembly.
Fig 2: Checking Voltage Between ECM Terminal 71 (Battery Current Sensor Signal) And Ground
G04900633Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.