Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Infiniti G37 Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
Component Inspection (ASCD Clutch Switch)
- CHECK ASCD CLUTCH SWITCH-I
- Turn ignition switch OFF.
- Disconnect ASCD clutch switch harness connector.
- Check the continuity between ASCD clutch switch terminals under the following conditions.TERMINAL CONTINUITY REFERENCE CHART
Terminals Condition Continuity 1 and 2 Clutch pedal Fully released Existed Slightly depressed Not existed Is the inspection result normal?
YES: INSPECTION END
NO: GO TO 2.
- CHECK ASCD CLUTCH SWITCH-II
- Adjust ASCD clutch switch installation. Refer to "INSPECTION AND ADJUSTMENT ".
- Check the continuity between ASCD clutch switch terminals under the following conditions.TERMINAL CONTINUITY REFERENCE CHART
Terminals Condition Continuity 1 and 2 Clutch pedal Fully released Existed Slightly depressed Not existed Is the inspection result normal?
YES: INSPECTION END
NO: Replace ASCD clutch switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.