Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Infiniti EX35 Base, AWDFACTORY OEM SERVICE PROCEDURE
Component Inspection (ICC Brake Hold Relay)
- CHECK ICC BRAKE HOLD RELAY
- Turn ignition switch OFF.
- Remove ICC brake hold relay.
- Check the continuity between ICC brake hold relay terminals under the following conditions.CONTINUITY CHART
Terminal Condition Continuity 3 and 4 12 V direct current supply between terminal 1 and 2 Not existed No current supply Existed 6 and 7 12 V direct current supply between terminal 1 and 2 Existed No current supply Not existed Is the inspection result normal?
YES: INSPECTION END
NO: Replace ICC brake hold relay.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.