Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Infiniti M45 BaseFACTORY OEM SERVICE PROCEDURE
Self-Diagnostic Result
WARNING: This page is about a different car, the 2008 Infiniti M45 and 2008 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.
SELF-DIAGNOSTIC RESULT
| DTC | DTC Detection Condition | Possible cause |
|---|---|---|
| U1000: CAN COMM CIRCUIT | When BCM cannot communicate CAN communication signal continuously for 2 seconds or more. | CAN communication system |
| U1010: CONTROL UNIT (CAN) | When detecting error during the initial diagnosis of CAN controller of BCM. | BCM |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.