Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Infiniti M35 BaseFACTORY OEM SERVICE PROCEDURE
CONSULT-III Function (RAS/HICAS): Function
CONSULT-III can display each self-diagnostic item using the diagnostic test modes shown following.
SELF DIAGNOSTIC RESULT REFERENCE
| Self Diagnostic Result | Receives self-diagnosis results from the RAS control unit, and indicates DTCs and the number of malfunctions. |
| Data Monitor | Receives input/output signals from the RAS control unit and indicates and stores them to facilitate locating the causes of malfunctions. |
| Active Test | Sends command to the RAS control unit to change output signals and check operation of output system. |
| ECU identification | Displays the part number of the RAS control unit. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.