2009 Infiniti FX50FACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
ABS Actuator & Electric Unit (Control Unit) (E41) Left rear of engine compartment. See Figure.
AFS Control Unit (M16) Left end of dash. See Figure.
Around View Monitor Control Unit (B46) Under driver's seat. See Figure.
Automatic Drive Positioner Control Unit (M52) Left center of dash. See Figure.
AWD Control Unit (M105) Right end of dash. See Figure.
Back Door Control Unit (D123) Lower left side of back door. See Figure.
BCM (Body Control Module) (3) Right end of dash. See Figure.
Brake Booster Control Unit (B251) Right side of luggage compartment. See Figure.
Camera Control Unit (B50) Under driver's seat. See Figure.
CAN Gateway (M125) Right end of dash. See Figure.
ECM (Engine Control Module) (F101) Right end of dash. See Figure.
E-Suspension Control Unit (B38) Left side of luggage compartment. See Figure.
Fuel Pump Control Module (B31) Left "C" pillar. See Figure.
Low Tire Pressure Warning Control Unit (M96) Right side of dash. See Figure.
Occupant Detection System Control Unit (11) Under front passenger's seat. See Figure.
Power Steering Control Unit (M108) Right side of dash. See Figure.
Pre-Crash Seat Belt Control Unit (Driver Side) (1) Base of left "B" pillar. See Figure.
Pre-Crash Seat Belt Control Unit (Passenger Side) (2) Base of right "B" pillar. See Figure.
Remote Keyless Entry Receiver (M104) Right end of dash. See Figure.
Side Support Unit (Driver/Passenger) In respective front seat back.
TCM (Transmission Control Module) On automatic transmission.
Total Illumination Control Unit (M129) Right side of dash. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.