2009 Infiniti FX50FACTORY OEM SERVICE PROCEDURE

Component Function Check

  1. CHECK FUNCTION

    Check the operation with "INDICATOR" in "Active Test" mode with CONSULT-III.

    TEST ITEM DESCRIPTION

    Test item Condition
    INDICATOR RED ON Key warning lamp (red) illuminates
    RED IND Key warning lamp (red) blinks

    Is the inspection result normal?Β 

    YES: Key warning lamp in combination meter is OK.

    NO: Refer to "DIAGNOSIS PROCEDUREΒ ".

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.