Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Procedure
- INSPECTION STARTÂ
Turn ignition switch to START.
Is any cylinder ignited?Â
Yes or NoÂ
Yes: GO TO 2.
No: GO TO Â 3.
- CHECK OVERALL FUNCTIONÂ
With CONSULT-IIIÂ
- Start engine.
- Perform "POWER BALANCE" in "ACTIVE TEST" mode with CONSULT-III.
- Make sure that each circuit produces a momentary engine speed drop.
Without CONSULT-IIIÂ
- Start engine.
- Listen to each fuel injector operating sound.
Operating sound should exist.Â
OK or NGÂ
OK: INSPECTION ENDÂ
NG: GO TO 3.
- CHECK FUEL INJECTOR POWER SUPPLY CIRCUITÂ
- Turn ignition switch OFF.
- Disconnect fuel injector harness connectors.
- Turn ignition switch ON.
- Check voltage between fuel injector terminal 1 and ground with CONSULT-III or tester.
Voltage: Battery voltageÂ
OK or NGÂ
OK: GO TO Â 5.
NG: GO TO 4.
- DETECT MALFUNCTIONING PARTÂ
Check the following.
- Harness connectors M72, F102
- Fuse block (J/B) connector M4
- 15A fuse
- Harness for open or short between fuel injector and fuse
>> Repair open circuit or short to ground or short to power in harness or connectors.
- CHECK FUEL INJECTOR OUTPUT SIGNAL CIRCUIT FOR OPEN AND SHORTÂ
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check harness continuity between ECM terminals 21, 22, 23, 40, 41, 42, 44, 63 and fuel injector terminal 2. Refer to WIRING DIAGRAMÂ .
Continuity should exist.Â
- Also check harness for short to ground and short to power.
OK or NGÂ
OK: GO TO 6.
NG: Repair open circuit or short to ground or short to power in harness or connectors.
- CHECK FUEL INJECTORÂ
Refer to "COMPONENT INSPECTIONÂ ".
OK or NGÂ
OK: GO TO 7.
NG: Replace fuel injector.
- CHECK INTERMITTENT INCIDENTÂ
Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".
>> INSPECTION ENDÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
