2008 Infiniti M35 BaseFACTORY OEM SERVICE PROCEDURE

Brake Control System DTCS: C1142-C1185

DTC INDEX - C1142-C1185

DTC Items (CONSULT screen items) Reference
C1142 PRESS SEN CIRCUIT ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
C1143 ST ANG SEN CIRCUIT YAW RATE/SIDE G SENSOR CIRCUIT
C1144 ST ANG SEN SIGNAL (Note 1)
C1145 YAW RATE SENSOR SOLENOID, VDC CHANGE-OVER VALVE AND ACTUATOR RELAY CIRCUIT
C1146 SIDE G-SEN CIRCUIT
C1147 USV LINE [FL-RR]
C1148 USV LINE [FR-RL]
C1149 HSV LINE [FL-RR]
C1150 HSV LINE [FR-RL]
C1153 EMERGENCY BRAKE ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
C1155 BR FLUID LEVEL LOW BRAKE FLUID LEVEL SWITCH CIRCUIT
C1156 ST ANG SEN COM CIR (Note 2) CAN COMMUNICATION CIRCUIT
C1170 VARIANT CODING ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
C1185 ACC CONT ICC SENSOR INTEGRATED UNIT CIRCUIT (WITH ICC)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.