Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Infiniti M35 BaseFACTORY OEM SERVICE PROCEDURE
P0700 - P0745
NOTE:
- If DTC U1000 or U1001 is displayed with other DTC, first perform the trouble diagnosis for DTC U1000, U1001. Refer to DTC U1000, U1001 CAN COMMUNICATION LINE .
- If DTC U1010 is displayed with other DTC, first perform the trouble diagnosis for DTC U1010. Refer to DTC U1010 CAN COMMUNICATION .
DTC - P0700 - P0745
| DTC(1) | Items (CONSULT-III screen terms) | Reference | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| CONSULT-III GST(2) | ECM(3) | ||||||||||
| P0700 | 0700 | TCM | DTC P0700 TCM | ||||||||
| P0705 | 0705 | PNP SW/CIRC | DTC P0705 PARK/NEUTRAL POSITION SWITCH | ||||||||
| P0710 | 0710 | ATF TEMP SEN/CIRC | DTC P1710 A/T FLUID TEMPERATURE SENSOR CIRCUIT | ||||||||
| P0717 | 0717 | TURBINE SENSOR | DTC P0717 TURBINE REVOLUTION SENSOR | ||||||||
| P0720 | 0720 | VEH SPD SEN/CIR AT(4) | DTC P0720 VEHICLE SPEED SENSOR A/T (REVOLUTION SENSOR) | ||||||||
| P0725 | 0725 | ENGINE SPEED SIG | DTC P0725 ENGINE SPEED SIGNAL | ||||||||
| P0740 | 0740 | TCC SOLENOID/CIRC | DTC P0740 TORQUE CONVERTER CLUTCH SOLENOID VALVE | ||||||||
| P0744 | 0744 | A/T TCC S/V FNCTN | DTC P0744 A/T TCC S/V FUNCTION (LOCK UP) | ||||||||
| P0745 | 0745 | L/PRESS SOL/CIRC | DTC P0745 LINE PRESSURE SOLENOID VALVE | ||||||||
|
|||||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.