Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2008 Infiniti G35 BaseFACTORY OEM SERVICE PROCEDURE

Component Inspection

CHECK ACCELERATOR PEDAL POSITION SENSOR

Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Turn ignition switch ON.

Check the voltage ECM harness connector and ground.

TERMINALS VOLTAGE REFERENCE

ECM		Ground	Condition		Voltage
Connector	Terminal	Ground	Condition		Voltage
M107	97 (APP sensor 1)	Ground	Accelerator pedal	Fully released	0.5 - 1.0V
	97 (APP sensor 1)			Fully depressed	4.2 - 4.8V
	98 (APP sensor 2)			Fully released	0.25 - 0.50V
	98 (APP sensor 2)			Fully depressed	2.0 - 2.5V

Is the inspection result normal?

YES: INSPECTION END

NO: GO TO 2.

REPLACE ACCELERATOR PEDAL ASSEMBLY
1. Replace accelerator pedal assembly.
2. Go to "SPECIAL REPAIR REQUIREMENT ".
  INSPECTION END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.