Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Infiniti G35 BaseFACTORY OEM SERVICE PROCEDURE
Ignition Relay Malfunction Detection Function
- IPDM E/R monitors the voltage at the contact circuit and excitation coil circuit of the ignition relay inside it.
- IPDM E/R judges the ignition relay error if the voltage differs between the contact circuit and the excitation coil circuit.
- If the ignition relay cannot turn OFF due to contact seizure, it activates the tail lamp relay for 10 minutes to alert the user to the ignition relay malfunction when the ignition switch is turned OFF.
IGNITION RELAY MALFUNCTION DETECTION FUNCTION CHART
| DTC | Ignition switch | Ignition relay | Tail lamp relay |
|---|---|---|---|
| - | ON | ON | - |
| - | OFF | OFF | - |
| B2098: IGN RELAY ON | OFF | ON | ON (10 minutes) |
| B2099: IGN RELAY OFF | ON | OFF | - |
NOTE:
The tail lamp turns OFF when the ignition switch is turned ON.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.