2008 Infiniti EX35 Base, RWDFACTORY OEM SERVICE PROCEDURE

DTC Detection Logic

DTC DETECTING CONDITION AND POSSIBLE CAUSE REFERENCE

DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P2127 Accelerator pedal position sensor 2 circuit low input An excessively low voltage from the APP sensor 2 is sent to ECM.
  • Harness or connectors (APP sensor 2 circuit is open or shorted.)

    [CKP sensor (POS) circuit is shorted.]

    [CMP sensor (PHASE) (bank 2) circuit is shorted.]

    [EVT control position sensor (bank 2) circuit is shorted.]

    (Battery current sensor circuit is shorted.)

    (EVAP control system pressure sensor circuit is shorted.)

    (Refrigerant pressure sensor circuit is shorted.)

  • Accelerator pedal position sensor (APP sensor 2)
  • Crankshaft position sensor (POS)
  • Camshaft position sensor (PHASE) (bank 2)
  • Exhaust valve timing control position sensor (bank 2)
  • Battery current sensor
  • EVAP control system pressure sensor
  • Refrigerant pressure sensor
P2128 Accelerator pedal position sensor 2 circuit high input An excessively high voltage from the APP sensor 2 is sent to ECM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.