2008 Infiniti EX35 Base, RWDFACTORY OEM SERVICE PROCEDURE

DTC Detection Logic

NOTE: If DTC P1239 or P2135 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. Refer to "DTC LOGIC ".
DTC DETECTING CONDITION AND POSSIBLE CAUSE REFERENCE

DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P1239 Throttle position sensor (bank 2) circuit range/performance Rationally incorrect voltage is sent to ECM compared with the signals from TP sensor 1 and TP sensor 2.
  • Harness or connector (TP sensor 1 and 2 circuit is open or shorted.)
  • Electric throttle control actuator (TP sensor 1 and 2)
P2135 Throttle position sensor (bank 1) circuit range/performance
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.