2008 Infiniti EX35 Base, RWDFACTORY OEM SERVICE PROCEDURE

Component Inspection

  1. CHECK THROTTLE POSITION SENSOR
    1. Turn ignition switch OFF.
    2. Reconnect all harness connectors disconnected.
    3. Perform "THROTTLE VALVE CLOSED POSITION LEARNING : SPECIAL REPAIR REQUIREMENT ".
    4. Turn ignition switch ON.
    5. Set selector lever to D position.
    6. Check the voltage between ECM harness connector terminals under the following conditions.
      VOLTAGE SPECIFICATIONS

      ECM Condition Voltage (V)
      Connector + -
      Terminal Terminal
      F101 30 [TP sensor 1 (bank 1)] 40 Accelerator pedal : Fully released More than 0.36
      Accelerator pedal : Fully depressed Less than 4.75
      31 [TP sensor 1 (bank 2)] 48 Accelerator pedal : Fully released More than 0.36
      Accelerator pedal : Fully depressed Less than 4.75
      34 [TP sensor 2 (bank 1)] 40 Accelerator pedal : Fully released Less than 4.75
      Accelerator pedal : Fully depressed More than 0.36
      35 [TP sensor 2 (bank 2)] 48 Accelerator pedal : Fully released Less than 4.75
      Accelerator pedal : Fully depressed More than 0.36

    Is the inspection result normal?Β 

    YES: INSPECTION END

    NO: GO TO 2.

  2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
    1. Replace malfunctioning electric throttle control actuator.
    2. Go to "SPECIAL REPAIR REQUIREMENTΒ ".

    INSPECTION END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.