2008 Infiniti EX35 Base, RWDFACTORY OEM SERVICE PROCEDURE

DTC Detection Logic

NOTE:
  • If DTC P1217 is displayed with DTC U1000 or U1001, first perform the trouble diagnosis for DTC U1000, U1001. Refer to "DTC LOGIC ".
  • If DTC P1217 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. Refer to "DTC LOGIC ".

If the cooling fan or another component in the cooling system malfunctions, engine coolant temperature will rise.

When the engine coolant temperature reaches an abnormally high temperature condition, a malfunction is indicated.

DTC DETECTING CONDITION AND POSSIBLE CAUSE REFERENCE

DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P1217 Engine over temperature (Overheat)
  • Cooling fan does not operate properly (Overheat).
  • Cooling fan system does not operate properly (Overheat).
  • Engine coolant was not added to the system using the proper filling method.
  • Engine coolant is not within the specified range.
  • Harness or connectors (The cooling fan circuit is open or shorted.)
  • IPDM E/R
  • Cooling fan control module
  • Cooling fan motor
  • Radiator hose
  • Radiator
  • Radiator cap
  • Water pump
  • Thermostat
CAUTION: When a malfunction is indicated, be sure to replace the coolant. Refer to "DRAINING " and "REFILLING ". Also, replace the engine oil. Refer to "DRAINING "and "REFILLING ".
  1. Fill radiator with coolant up to specified level with a filling speed of 2 liters per minute. Be sure to use coolant with the proper mixture ratio. Refer to "ANTI-FREEZE COOLANT MIXTURE RATIO ".
  2. After refilling coolant, run engine to ensure that no water-flow noise is emitted.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.