2008 Infiniti EX35 Base, RWDFACTORY OEM SERVICE PROCEDURE

DTC Detection Logic

The ECM monitors the switching frequency ratio of air fuel ratio (A/F) sensor 1 and heated oxygen sensor 2. A three way catalyst 1 with high oxygen storage capacity will indicate a low switching frequency of heated oxygen sensor 2. As oxygen storage capacity decreases, the heated oxygen sensor 2 switching frequency will increase.

When the frequency ratio of A/F sensor 1 and heated oxygen sensor 2 approaches a specified limit value, the three way catalyst 1 malfunction is diagnosed.

Fig 1: Identifying Three Way Catalyst Function
G04875200Courtesy of NISSAN MOTOR CO., U.S.A.
DTC DETECTING CONDITION AND POSSIBLE CAUSE REFERENCE

DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P0420 Catalyst system efficiency below threshold (bank 1)
  • Three way catalyst (manifold) does not operate properly.
  • Three way catalyst (manifold) does not have enough oxygen storage capacity.
  • Three way catalyst (manifold)
  • Exhaust tube
  • Intake air leaks
  • Fuel injector
  • Fuel injector leaks
  • Spark plug
  • Improper ignition timing
P0430 Catalyst system efficiency below threshold (bank 2)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.