2008 Infiniti EX35 Base, RWDFACTORY OEM SERVICE PROCEDURE

DTC Detection Logic

NOTE: If DTC P0340 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. Refer to "DTC LOGIC ".
DTC DETECTING CONDITION AND POSSIBLE CAUSE REFERENCE

DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P0340 Camshaft position sensor (PHASE) (bank 1) circuit
  • The cylinder No. signal is not sent to ECM for the first few seconds during engine cranking.
  • The cylinder No. signal is not sent to ECM during engine running.
  • The cylinder No. signal is not in the normal pattern during engine running.
  • Harness or connectors

    [CMP sensor (PHASE) (bank 1) circuit is open or shorted.]

  • Camshaft position sensor (PHASE) (bank 1)
  • Camshaft (INT)
  • Starter motor
  • Starting system circuit
  • Dead (Weak) battery
P0345 Camshaft position sensor (PHASE) (bank 2) circuit
  • Harness or connectors

    [CMP sensor (PHASE) (bank 2) circuit is open or shorted.]

    [CKP sensor (POS) circuit is shorted.]

    [EVT control position sensor (bank 2) circuit is shorted.]

    (Battery current sensor circuit is shorted.)

    (APP sensor 2 circuit is shorted.)

    (EVAP control system pressure sensor circuit is shorted.)

    (Refrigerant pressure sensor circuit is shorted.)

  • Camshaft position sensor (PHASE) (bank 2)
  • Crankshaft position sensor (POS)
  • Exhaust valve timing control position sensor (bank 2)
  • Battery current sensor
  • Accelerator pedal position sensor
  • EVAP control system pressure sensor
  • Refrigerant pressure sensor
  • Camshaft (INT)
  • Starter motor
  • Starting system circuit
  • Dead (Weak) battery
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.