2008 Infiniti EX35 Base, RWDFACTORY OEM SERVICE PROCEDURE

Component Inspection

  1. CHECK CAMSHAFT POSITION SENSOR (PHASE)-I
    1. Turn ignition switch OFF.
    2. Loosen the fixing bolt of the sensor.
    3. Disconnect camshaft position sensor (PHASE) harness connector.
    4. Remove the sensor.
    5. Visually check the sensor for chipping.
    Fig 1: Identifying Camshaft Position Sensor (Phase)-I
    G04886870Courtesy of NISSAN MOTOR CO., U.S.A.

    Is the inspection result normal? 

    YES: GO TO 2.

    NO: Replace malfunctioning camshaft position sensor (PHASE).

  2. CHECK CAMSHAFT POSITION SENSOR (PHASE)-II

    Check resistance camshaft position sensor (PHASE) terminals as follows.

    RESISTANCE SPECIFICATIONS

    Terminals (Polarity) Resistance
    1 (+) - 2 (-) Except 0 or ∞Ω [at 25°C (77°F)]
    1 (+) - 3 (-)
    2 (+) - 3 (-)

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Replace malfunctioning camshaft position sensor (PHASE).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.