Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Infiniti EX35 Base, RWDFACTORY OEM SERVICE PROCEDURE
Component Description
COMPONENTS REFERENCE
| Component parts | Reference | |
|---|---|---|
| ABS actuator and electric unit (control unit) | Pump | DESCRIPTION |
| Motor | ||
| Actuator relay (main relay) | DESCRIPTION | |
| Solenoid valve | DESCRIPTION | |
| Pressure sensor | DESCRIPTION | |
| VDC switch-over valve (USV1, USV2, HSV1, HSV2) | DESCRIPTION | |
| Wheel sensor | DESCRIPTION | |
| Yaw rate/side G sensor | DESCRIPTION | |
| Steering angle sensor | DESCRIPTION | |
| VDC OFF switch | DESCRIPTION | |
| ABS warning lamp | DESCRIPTION | |
| Brake warning lamp | DESCRIPTION | |
| VDC OFF indicator lamp | DESCRIPTION | |
| SLIP indicator lamp | DESCRIPTION | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.