Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Infiniti EX35 Base, RWDFACTORY OEM SERVICE PROCEDURE
Input/Output Signal Table
INPUT/OUTPUT SIGNAL TABLE
| Switch | Input signal to BCM | BCM function | Actuator |
|---|---|---|---|
| Push-button ignition switch | Push switch | Engine start function |
|
| Control device | P range | ||
| PNP switch | N, P range | ||
| Stop lamp switch | Brake ON/OFF | ||
| Each inside key antenna | Request signal | ||
| Remote keyless entry receiver | Key ID | ||
| Each door switch | Door open/close | ||
| ECM | Engine status signal |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
