Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnosis Procedure
- CHECK DTC
Check that DTC U1000 or U1001 is not displayed.
Is the inspection result normal?
YES: GO TO 2.
NO: Perform trouble diagnosis for DTC U1000, U1001. Refer to "DIAGNOSIS PROCEDURE ".
- CHECK DTC WITH "UNIFIED METER AND A/C AMP."
Refer to "CONSULT-III FUNCTION (METER/M&A) ".
Is the inspection result normal?
YES: GO TO 3.
NO: Repair or replace malfunctioning part.
- CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".
Is the inspection result normal?
YES: Replace combination meter.
NO: Repair or replace malfunctioning part.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.