Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2008EX35 BASE, AWDREPAIR AND DIAGNOSISBRAKESBRAKES CONTROL SYSTEMSBRAKE CONTROL SYSTEM
2008 Infiniti EX35 Base, AWD
Brake Control System
2008 Infiniti EX35 Base, AWDSECTION Brake Control System
- Basic Inspection
- Function Diagnosis
- Component Diagnosis
- DTC Index
- DTC C1101, C1102, C1103, C1104: Wheel Sensor
- DTC C1105, C1106, C1107, C1108: Wheel Sensor
- DTC C1109: Power And Ground System
- DTC C1110, C1153, C1170: Abs Actuator And Electric Unit (Control Unit)
- DTC C1111: Abs Motor, Motor Relay System
- DTC C1114: Actuator Relay System
- DTC C1115: Wheel Sensor
- DTC C1116: Stop Lamp Switch
- DTC C1120, C1122, C1124, C1126: In Abs Sol
- DTC C1121, C1123, C1125, C1127: Out Abs Sol
- DTC C1130: Engine Signal
- DTC C1142: Press Sensor
- DTC C1143: Steering Angle Sensor
- DTC C1144: Steering Angle Sensor
- DTC C1145, C1146: Yaw Rate/Side G Sensor
- DTC C1147, C1148, C1149, C1150: USV/HSV Line
- DTC C1154: PNP Switch
- DTC C1155: Brake Fluid Level Switch
- DTC C1185: ICC Unit
- DTC U1000: Can Comm Circuit
- DTC U1100: Can Comm Circuit (ICC Unit)
- Power Supply And Ground Circuit
- Parking Brake Switch
- VDC Off Switch
- Abs Warning Lamp
- Brake Warning Lamp
- VDC Off Indicator Lamp
- Slip Indicator Lamp
- Ecu Diagnosis
- Symptom Diagnosis
- Precaution
- Preparation
- On-Vehicle Repair
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.