2007 Infiniti M35 BaseFACTORY OEM SERVICE PROCEDURE

Key Reminder Function

Key reminder functions have the following 3 functions.

KEY REMINDER FUNCTION

Key remainder function Operation condition Operation
Driver door close(1) Right after driver side door is closed under the following conditions
  • Door lock operation is performed
  • Driver side door is opened
  • Driver side door is in unlock state
 All doors unlock
Door is open or closed Right after all doors are closed under the following conditions
  • Intelligent Key is inside the vehicle
  • Any door is opened
  • All doors are locked by door lock and unlock switch or door lock knob
  • All doors unlock
  • Honk Intelligent Key warning buzzer
Trunk is closed Right after trunk is closed under the following conditions
  • Intelligent Key is inside trunk room
  • all doors are closed
  • all doors are locked
  • Trunk open
  • Honk Intelligent Key warning buzzer
(1) If the door closing impact shocks the door lock knob, or contacts against baggage with the door lock knob might activate the door locks accidentally but unlock operation will be perform at these cases.
CAUTION:
  • The above function operates when the Intelligent Key is inside the vehicle. However, there may be times when the Intelligent Key cannot be detected, and this function will not operate when the Intelligent Key is on the instrument panel, rear parcel shelf, or in the glove box. Also, this system sometimes does not operate if the Intelligent Key is in the door pocket for the open door.
  • When the key reminder function is operated when the trunk is open/closed and the buzzers sound, if the following operations are performed, the key reminder function is cleared and buzzer sounds are stopped.
    • Remote controller door lock button operation of Intelligent Key
    • Remote controller door unlock button operation of Intelligent Key
    • When the trunk is closed, the Intelligent Key is not inside the vehicle
    • When any door is open
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.