2007 Infiniti M35 BaseFACTORY OEM SERVICE PROCEDURE

Check Push-Button Ignition Switch

  1. CHECK POWER SUPPLY CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect push-button ignition switch connector.
    3. Check voltage between push-button ignition switch connector and ground.
      TERMINAL VOLTAGE CHART

      Terminals Voltage (V) (Approx.)
      (+) (-)
      push-button ignition switch connector Terminal
      M27 4 Ground Battery voltage

    OK or NG 

    OK: GO TO  3.

    NG: GO TO 2.

    Fig 1: Checking Voltage Between Push-Button Ignition Switch Connector Terminal 4 And Ground
    G05212348
  2. CHECK HARNESS CONTINUITY 
    1. Disconnect Intelligent Key unit connector.
    2. Check continuity between Intelligent Key unit connector and push-button ignition switch connector.
      TERMINAL CONTINUITY CHART

      A B Continuity
      Intelligent Key unit connector Terminal push-button ignition switch connector Terminal
      M32 39 M27 4 Yes
    3. Check continuity between Intelligent Key unit connector and ground.
      Fig 2: Checking Continuity Between Intelligent Key Unit Connector And Push-Button Ignition Switch Connector
      G05212333
      TERMINAL CONTINUITY CHART

      A Ground Continuity
      Intelligent Key unit connector Terminal
      M32 39 No

    OK or NG 

    OK: GO TO 3.

    NG: Repair or replace harness.

  3. CHECK PUSH-BUTTON IGNITION SWITCH 

    Check push-button ignition switch.

    TERMINAL REFERENCE CHART

    Terminal Push-button ignition switch condition Continuity
    Push-button ignition switch
    1 4 Pushed Yes
    Released No

    OK or NG 

    OK: GO TO 4.

    NG: Replace push-button ignition switch.

    Fig 3: Checking Push-Button Ignition Switch
    G05212334
  4. CHECK GROUND CIRCUIT 

    Check push-button ignition switch connector.

    TERMINAL REFERENCE CHART

    Push-button ignition switch connector Terminal Ground Continuity
    M27 1 Yes

    OK or NG 

    OK: Check the condition of harness and connector.

    NG: Repair or replace harness.

    Fig 4: Checking Push-Button Ignition Switch Connector Terminal 1 And Ground
    G05212351
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.