Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Infiniti M35 BaseFACTORY OEM SERVICE PROCEDURE
Data Monitor
MONITOR ITEM CHART
| Monitor item | Content | ||
|---|---|---|---|
| DR REQ SW | Indicates [ON/OFF] condition of door request switch (driver side). | ||
| AS REQ SW | Indicates [ON/OFF] condition of door request switch (passenger side). | ||
| BD/TR REQ SW | Indicates [ON/OFF] condition of trunk opener request switch. | ||
| ON POS | Indicates [ON/OFF] condition of ignition switch in ON position. | ||
| ACC POS | Indicates [ON/OFF] condition of ignition switch in ACC position. | ||
| DOOR STAT SW | Indicates [ON/OFF] condition of door unlock sensor. | ||
| STOP LAMP SW | Indicates [ON/OFF] condition of stop lamp switch. | ||
| P RANGE SW | Indicates [ON/OFF] condition of park position switch. | ||
| TR CANCEL SW(1) | Indicates [ON/OFF] condition of trunk cancel switch. | ||
| DOOR LOCK SIG(1) | Indicates [ON/OFF] condition of door lock signal from Intelligent Key remote controller button. | ||
| DOOR UNLOCK SIG(1) | Indicates [ON/OFF] condition of door unlock signal from Intelligent Key remote controller button. | ||
| KEYLESS TRUNK(1) | Indicates [ON/OFF] condition of trunk open signal from Intelligent Key remote controller button. | ||
| KEYLESS PANIC(1) | Indicates [ON/OFF] condition of panic alarm signal from Intelligent Key remote controller button. | ||
| DOOR SW DR(1) | Indicates [OPEN/CLOSE] condition of front door switch driver side from BCM via CAN communication line. | ||
| DOOR SW AS(1) | Indicates [OPEN/CLOSE] condition of front door switch passenger side from BCM via CAN communication line. | ||
| DOOR SW RR(1) | Indicates [OPEN/CLOSE] condition of rear door switch LH from BCM via CAN communication line. | ||
| DOOR SW RL(1) | Indicates [OPEN/CLOSE] condition of rear door switch RH from BCM via CAN communication line. | ||
| DOOR BK SW(1) | Indicates [OPEN/CLOSE] condition of back door switch from BCM via CAN communication line. | ||
| TRUNK SW(1) | Indicates [OPEN/CLOSE] condition of trunk room lamp switch from BCM via CAN communication line. | ||
| VEHICLE SPEED(1) | Indicates [km/h] condition of vehicle speed. | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.