2007 Infiniti M35 BaseFACTORY OEM SERVICE PROCEDURE

Items Of Each Part

CONSULT-II BASIC OPERATION

x: Applicable
System and item CONSULT-II display Diagnostic test mode (Inspection by part)
WORK SUPPORT SELF-DIAG RESULTS DATA MONITOR CAN DIAG SUPPORT MNTR ACTIVE TEST ECU PART NUMBER
BCM BCM x x   x   x
Power door lock system DOOR LOCK     x   x  
Rear window defogger REAR DEFOGGER     x   x  
Warning chime BUZZER     x   x  
Room lamp timer INT LAMP x   x   x  
Headlamp HEAD LAMP x   x   x  
Wiper WIPER x   x   x  
Turn signal lamp Hazard lamp FLASHER     x   x  
Intelligent Key system INTELLIGENT KEY     x   x  
Combination switch COMB SW     x      
IVIS IMMU     x   x  
Room lamp battery saver BATTERY SAVER x   x   x  
Trunk lid TRUNK     x   x  
Vehicle security system THEFT ALM x   x   x  
Retained power control RETAINED PWR x   x      
Oil pressure switch SIGNAL BUFFER     x   x  
Panic system PANIC ALARM         x  
NOTE: CONSULT-II displays systems equipped in the vehicle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.