2007 Infiniti FX45FACTORY OEM SERVICE PROCEDURE

Control Device Removal and Installation: Removal

CAUTION: Make sure that parking brake is applied before removal/installation.
  1. Disconnect lower lever of control device and control rod.
  2. Remove knob cover (1) below selector lever downward.
  3. Pull lock pin (2) out of selector lever knob (3).
    Fig 1: Identifying Knob Cover, Lock Pin Of Selector Lever Knob
    G05218126Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove selector lever knob (3).
  5. Remove A/T console finisher. Refer to "COMPONENT PARTS DRAWING ".
  6. Remove center console. Refer to "COMPONENT PARTS DRAWING ".
  7. Remove rear ventilator duct 2. Refer to "REMOVAL AND INSTALLATION ".
  8. Remove key interlock cable (1) from control device. Refer to "REMOVAL AND INSTALLATIONΒ ".
  9. Fig 2: Identifying Key Interlock Cable And A/T Device Harness Connector
    G05218127Courtesy of NISSAN MOTOR CO., U.S.A.
  10. Disconnect A/T device harness connector (2).
  11. Remove control device assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.